Is the drive selection jumper setting on the back of the CD-ROM drive correct?
Action:
WARNING: Electrical shock hazard! Make sure the power is turned off and the external power cables have been disconnected before removing the computer cover.
CAUTION 1: This task should be performed by a qualified computer technician.
CAUTION 2: Please observe steps to reduce the potential damage to computer components from electro-static discharge.
1) Make sure the drive select jumper is set to one of the following:
a) If the CD-ROM drive is configured as the only or primary device using the EIDE controller, the drive selection jumper should be left at the manufacturer settings.
b) If the CD-ROM drive is configured as the second of two devices using the EIDE controller, the drive selection jumper must be set to 'Slave'.
Question:
Is the drive selection jumper setting on the back of the CD-ROM drive correct?
Responses:
Yes, the drive selection jumper setting is correct
No, the drive selection jumper setting is incorrect
